Miller XT30C 소유자 매뉴얼 - 페이지 26

{카테고리_이름} Miller XT30C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller XT30C 40 페이지.
Miller XT30C에 대해서도 마찬가지입니다: 매뉴얼 (40 페이지)

페이지 인쇄
Miller XT30C 소유자 매뉴얼
.
A complete Parts List is available at www.MillerWelds.com

5-6. Sequence Of Piercing Operation

!
The pilot arc starts immediately
when trigger is pressed.
°
45
Connect work clamp to a clean, paint-free
Hold torch at approximately 45°
location on workpiece, as close to cutting
to the workpiece. Raise trigger
area as possible.
lock and press trigger. Pilot arc
starts.
°
90
°
90
°
Rotate torch to upright position
Release trigger. Postflow continues for
Maintain approximately 90
torch
°
approx. 20 seconds after releasing trigger;
approximately 90
to surface.
position to surface, and continue
arc can be instantly restarted during postflow
When arc has pierced through
cutting.
by raising trigger lock and pressing trigger.
workpiece, start cutting.
Ref. 254 087-A
OM-255 590 Page 22