Miller 20 Series 소유자 매뉴얼 - 페이지 21

{카테고리_이름} Miller 20 Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller 20 Series 36 페이지.

페이지 인쇄
Miller 20 Series 소유자 매뉴얼

5-7. Motor Start/Burnback Control

Tools Needed:
Non-Conductive
1/4 in.
Notes
1
2
3
!
Turn Off wire feeder and
welding power source. Stop
engine on welding generator.
To change wire feed starting speed
proceed as follows:
Turn Off unit and welding power
source.
Remove wrapper.
1
Motor Board PC1
2
Motor Start Control
Potentiometer R73
Remove protective white rubber cap
before making adjustment. Adjust
potentiometer R73 using a small
nonconductive screwdriver. Rotate
potentiometer clockwise to increase
time it takes the motor to ramp up to
speed.
3
Burnback Potentiometer R42
Remove protective white rubber cap
before making adjustment. Adjust
potentiometer R42 using a small
nonconductive screwdriver. Rotate
potentiometer clockwise to increase
burnback time.
Reinstall wrapper.
Ref. 240357-D
OM-281138 Page 17