Miller AA40G 소유자 매뉴얼 - 페이지 20
{카테고리_이름} Miller AA40G에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller AA40G 28 페이지.
페이지 인쇄
5-6. Threading And Feeding Welding Wire
ON
V
OFF
POWER
Turn on power at welding power source.
Pressure
Indicator
Scale
JOG
Push wire thru guide up to drive rolls; continue to
hold welding wire. Press power source Jog push
button until drive rolls grab wire. Adjust tension until
wire does not slip. Indicator is for reference only.
OM-200580 Page 16
Tools Needed:
Welding Power Source
PURGE
JOG
Pressure
Adjust
Press Jog push button until wire comes
out of gun. Feed wire to check drive roll
pressure. Adjust knob enough to pre-
vent slipping.
Hold wire tightly to keep it
from unraveling.
6 in
(150 mm)
Pull and hold wire; cut off end.
WOOD
Ref. ST-153 072-A / Ref. ST-156 798 / 802 914
Cut off wire. Close cover.