Miller ArcStation 30FX 소유자 매뉴얼 - 페이지 18
{카테고리_이름} Miller ArcStation 30FX에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller ArcStation 30FX 24 페이지.
페이지 인쇄
B. Optional Work Lead Tab Position
Tools Needed:
hex bit 3/16 in.
DD
C. Grounding The Welding Table
2
OM-250 085 Page 14
1
2
Rear
2
Top View
Rear
1
Top View
2
1
Tools Needed:
hex bit 3/16 in.
1
Tapped Holes For Work Lead
Tab
2
Work Lead Tab
Attach work lead tab with one bolt
DD to bottom side and at the rear of
the top using either one of the two
tapped holes.
!
Connect welding table to a
good
electrical
ground
(independent of the welding
leads)
unless
a
qualified
person assures it is safe to
work
on
an ungrounded
workpiece.
1
Ground Bolt
2
Tapped Hole For Ground Bolt
Use the supplied ground bolt GG to
connect the welding table to a good
electrical ground according to
national, state, and local codes.