Miller Axcess 675 소유자 매뉴얼 - 페이지 29
{카테고리_이름} Miller Axcess 675에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Axcess 675 48 페이지. Automatic welding interface and arc welding power source
Miller Axcess 675에 대해서도 마찬가지입니다: 소유자 매뉴얼 (48 페이지)
페이지 인쇄6-1. Front Panel Switches
2
1
1
Power Switch
Turns unit On or Off.
6-2. Options
A. E-Stop Option
The E-Stop option comes with a 2-pin amphenol receptacle, matching plug, and 30 ft (9 m) of high density molded cord to allow connecting the welding
power source into an E-Stop circuit. An integrator will need to supply a closure for the non E-Stop condition.
When the E-Stop input connection changes it state from closed to open, the welding power source goes into an E-Stop mode where all welding outputs
shutdown immediately. Once the input connection returns to a closed state, the unit will start a reset routine and be ready for operation when it com-
pletes the reset operation.
B. DeviceNet Option
The DeviceNet option provides hardware and software that allows the welding power source to be connected into a DeviceNet network.
Contact factory for option details.
C. RMD Option
RMD (Regulated Metal Deposition) is a precisely controlled short-circuit transfer welding process. Some of the benefits provided by the RMD process
are the ability to weld thin gauge material and use larger diameter welding wire on thin gauge material, improved gap filling, reduction of spatter, less
heat input into the workpiece, and less distortion.
The RMD process is a software option that is loaded into the welding power source.
Contact factory for option details.
D. Accuspeed Option
Accuspeed is a CV Pulse process designed for high travel speeds typically used in Robotic applications. Arc is designed to be tight and fast.
The Accuspeed process is a software option that is loaded into a welding power source.
Contact factory for option details.
SECTION 6 − OPERATION
2
Pilot Light
Light indicates status of welding power
source, on when unit is on and off when unit is
off.
3
4
3
PDA Port
4
PC Port
OM-217 751 Page 25
Ref. 803 824-A