Miller M-10 소유자 매뉴얼 - 페이지 31

{카테고리_이름} Miller M-10에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller M-10 48 페이지. Air-cooled guns for gmaw and fcaw welding
Miller M-10에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지)

페이지 인쇄

8-2. Typical MIG Process Control Settings

NOTE

Material thickness determines weld

parameters.

These settings are guidelines only. Material and wire type, joint design, fitup,

position, shielding gas, etc. affect settings. Test welds to be sure they comply to

specifications.

Low voltage: wire stubs into work

High voltage: arc is unstable (spatter)

Set voltage midway between high/low voltage.

1/8 or

.125 in

Voltage controls height and width of

weld bead.

Wire speed (amperage) controls weld penetration

(wire speed = burn-off rate)

Convert Material

Thickness to

Amperage (A)

(.001 in = 1 ampere)

.125 in = 125 A

Select Voltage

Ref. 803 809-A

OM-1328 Page 27