Miller Maxstar 161 S 소유자 매뉴얼 - 페이지 17

{카테고리_이름} Miller Maxstar 161 S에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Maxstar 161 S 44 페이지. Arc welding power source with auto-line

페이지 인쇄
Miller Maxstar 161 S 소유자 매뉴얼
4-5. Duty Cycle And Overheating For Maxstar 161STL And STH Models
250
Stick And TIG 240 V
200
150
TIG 120 V
100
50
Stick 120 V
0
10

4-6. Static Characteristics

The static (output) characteristics of the welding power source can be described as drooping during the SMAW and GTAW processes. Static
characteristics are also affected by control settings (including software), electrode, shielding gas, weldment material, and other factors. Contact
the factory for specific information on the static characteristics of the welding power source.

4-7. Remote 6 Receptacle Information (STL And STH Models Only)

.
A complete Parts List is available at www.MillerWelds.com
20
30
40
% Duty Cycle
15 VOLTS DC
OUTPUT
CONTACTOR
REMOTE
OUTPUT
CONTROL
Ref. 805575-A
CHASSIS
50
60
70
80 90
100
Socket
6
1
Contactor control +15 volts DC.
2
Contact closure to 1 completes contactor control
circuit and enables output when Lift-Arc TIG re-
mote is selected.
3
Output to remote control; +10 volts DC output to
remote control.
4
0 to +10 volts DC input command signal from
remote control.
5
Remote control circuit common.
6
Chassis common.
Duty Cycle is percentage of 10 min-
utes that unit can weld at rated load
without overheating.
If unit overheats, output stops, the
Overtemperature Light comes On,
Over Temp is displayed, and the
cooling fan runs. Wait fifteen min-
utes for unit to cool. Reduce amper-
age or duty cycle before starting to
weld again.
NOTICE − Exceeding duty cycle
can damage unit and void warranty.
Socket Information
OM-275099 Page 13