Miller Maxstar 161 S 소유자 매뉴얼 - 페이지 20
{카테고리_이름} Miller Maxstar 161 S에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Maxstar 161 S 44 페이지. Arc welding power source with auto-line
페이지 인쇄
5-4. Connecting 120 VAC Input Power
4
OM-275099 Page 16
.
A complete Parts List is available at www.MillerWelds.com
2
1
!
!
!
!
5
.
NOTICE − Do Not modify the
power cord. The power cord
plugs will work with standard NE-
MA receptacles. Use only the
power cords supplied with this
unit. Modifying the power cord(s)
and/or plugs, or using cords not
intended for use with this product
will void warranty.
For 120 volts AC input power, a
3
15 or 20 ampere individual
branch circuit protected
time-delay
breaker is required. For 240 volts
AC input power, see Section 5-5.
1
6
120 VAC cord with NEMA type 5
-15P plug and SDG plug.
2
3
4
5
6
Connect plug (3) to receptacle (5
or 6).
Do not move or operate
unit where it could tip.
Installation must meet all
National and Local Codes
− have only qualified
persons
make
this
installation.
Do not use power cord to
lift or carry welding power
source.
Special installation may be
required where gasoline or
volatile liquids are present
− see NEC Article 511 or
CEC Section 20.
The Auto-Line circuitry in this
unit automatically links the
power source to the primary
voltage being applied, either
120 or 240 VAC.
by
fuses
or
circuit
Power Cord 120 VAC
Plug - SDG
Plug - NEMA Type 5 - 15P
Receptacle - SDG
Receptacle - NEMA Type
5-15R
Receptacle - NEMA Type 6
- 20R
Ref. 803351-D