Miller S-74 Boom w/Drive 소유자 매뉴얼 - 페이지 20
{카테고리_이름} Miller S-74 Boom w/Drive에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller S-74 Boom w/Drive 32 페이지. Boom w/drive
Miller S-74 Boom w/Drive에 대해서도 마찬가지입니다: 소유자 매뉴얼 (32 페이지)
페이지 인쇄
4-11. Installing And Threading Welding Wire
Pressure
Adjust
Install drive rolls.
NONCONDUCTIVE
.
Be sure that outlet cable has proper size
liner for the welding wire size. When
installing
gun,
position
extending from outlet wire guide as
close as possible to drive rolls without
touching.
Install gun. Lay gun cable out straight. Cut off
end of wire. Push wire through guides up to
drive rolls; continue to hold wire. Press Jog
button to feed wire out gun.
OM-252 045 Page 16
Install wire spool. Ad-
just tension nut so
wire is taut when wire
feed stops.
Drive Rolls
Gun Cable
End Of Liner
NONCONDUCTIVE
SURFACE
SURFACE
No Wire Slip
Wire Slips
.
For soft wire or small diameter stainless
steel wire, reduce drive roll pressure on
liner
the rear roll to half that of the front rolls.
3/16, 5/64 in.
Pressure
Indicator
Scale
Pressure
Adjust
152 648-A / 802 865 / 802 966 / Ref. 137 391-A / 802 954 / Ref. S-0627-A / 805 416-A
Tools Needed:
15/16, 3/8 in.
Install wire guide.
.
To adjust drive roll pressure, hold nozzle
about 2 in. (51 mm) from nonconductive
surface and press gun trigger to feed wire
against surface. Tighten knob so wire
does not slip. Do not overtighten. If con-
tact tip is completely blocked, wire should
slip at the feeder (see pressure adjust-
ment above).Cut wire off. Close cover.