Miller S-74 Boom w/Drive 소유자 매뉴얼 - 페이지 19
{카테고리_이름} Miller S-74 Boom w/Drive에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller S-74 Boom w/Drive 32 페이지. Boom w/drive
Miller S-74 Boom w/Drive에 대해서도 마찬가지입니다: 소유자 매뉴얼 (32 페이지)
페이지 인쇄
4-10. Installing Welding Gun
4
3
Installing gun with
Accu-Mate connection
1
6
5
Installing gun without
Accu-Mate connection
2
1
1
Gun Locking Tab
2
Power Clamp Knob
3
Gun Connection End
4
Power Pin Groove
Installing gun with Accu-Mate
connection
Loosen power clamp knob to allow
power pin of gun to clear the gun
locking tab.
Push power pin into power clamp
as far as possible to align the
groove in the power pin of the gun
with the gun locking tab.
Secure gun by tightening power
clamp knob.
Installing gun without Accu-
Mate connection
When using a gun without the
groove in the power pin, loosen
power clamp knob and rotate gun
locking tab 180 degrees. This pre-
vents the locking tab from extend-
ing into the power pin gun connec-
tion.
Push power pin into power clamp
as far as possible.
Secure gun by tightening power
clamp knob.
5
Empty Pressure Slots
2
6
Pressure Blocking Clip
Installing A Push/Pull Gun
When using a push/pull gun, leave
pressure blocking clips in position.
Do not adjust pressure as shown in
Section 4-11.
Installing A Push Only Gun
When using a push only gun, re-
move the blocking clips and place
them in the empty pressure slots for
storage and adjust pressure as
shown in Section 4-11.
Ref. 249398-B
OM-252045 Page 15