Miller S-75SC 소유자 매뉴얼 - 페이지 21
{카테고리_이름} Miller S-75SC에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller S-75SC 40 페이지.
페이지 인쇄5-10. Installing Welding Gun
Installing gun with
Accu-Mate connection
1
3
Installing gun without
Accu-Mate connection
2
2
1
1
Power Clamp Knob
2
Gun Locking Tab
3
Power Pin Groove
4
Gun Connection End
Installing gun with Accu-Mate
connection
Loosen power clamp knob to allow
power pin of gun to clear the gun
locking tab.
When installing gun, the liner
should extend into the PD continu-
ous guide (or exit guide if used) as
far as possible without interfering
with the guide.
Align the groove in the power pin of
the gun with the gun locking tab.
Secure gun by tightening power
4
clamp knob.
Installing gun without Accu-
Mate connection
When using a gun without the
groove in the power pin, loosen
power clamp knob and rotate gun
locking tab 180 degrees. This pre-
vents the locking tab from extend-
ing into the power pin gun connec-
tion.
When installing gun, the liner
should extend into the PD continu-
ous guide (or exit guide if used) as
far as possible without interfering
with the guide.
Secure gun by tightening power
clamp knob.
804 189-C
OM-223 605 Page 17