Miller SUITCASE 12RC 소유자 매뉴얼 - 페이지 18
{카테고리_이름} Miller SUITCASE 12RC에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller SUITCASE 12RC 40 페이지. Wire feeder with gun and meters
Miller SUITCASE 12RC에 대해서도 마찬가지입니다: 사양 (2 페이지), 소유자 매뉴얼 (36 페이지), 소유자 매뉴얼 (40 페이지)
페이지 인쇄
5-3. Connecting Welding Gun
1
Gun Locking Tab In Place
Internal Side View
OM-263984 Page 14
5
2
Gun Locking Tab Out Of Place
3
4
6
!
Turn Off wire feeder and
welding power source.
Stop engine on welding
generator.
1
Gun Securing Knob
2
Gun Block
3
Gun Power Pin
4
Power Pin Groove
5
Gun Locking Tab
5
Loosen gun securing knob, insert
gun power pin into gun block. Po-
sition power pin as close as pos-
sible to drive rolls without touch-
ing. Align the gun power pin
groove with the gun locking tab.
Tighten gun securing knob.
If the gun power pin does not
have a groove, loosen knob to ro-
tate the gun locking tab 180 de-
grees. This prevents the gun
locking tab from interfering with
the gun power pin when inserted
into the gun block. Insert the gun
power pin into the gun block. Pos-
ition power pin as close as pos-
sible to drive rolls without touch-
ing them. Tighten gun securing
knob.
6
Gun Trigger Plug
7
Gun Trigger Receptacle
Connect gun trigger plug to gun
trigger receptacle.
7
256 617-A / 263 839-A