Miller T94 Series 매뉴얼 - 페이지 23
{카테고리_이름} Miller T94 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller T94 Series 32 페이지. Auto-darkening helmets
Miller T94 Series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (40 페이지)
페이지 인쇄
6-2. Replacing Lens Covers On Quick Release Helmets
2
1
!
Never
use
auto-darkening lens
without the inside
and outside lens cov-
ers
properly
installed.
Welding
spatter will damage
the auto-darkening
lens and void the
warranty.
Outside Lens Cover
1
Lens Holder
2
Lens Holder Release
Points
3
Outside Lens Cover
Remove lens holder by
pulling the holder away
from the helmet on either
side of lens holder.
2
3
Remove lens cover from
the
shell by pulling top center of
lens. Replace lens cover in
lens holder by placing one
edge in place, bending lens
cover, and inserting oppo-
site edge into lens holder
channel. Reinstall
holder in helmet.
Inside Lens Cover
4
Auto-Darkening Lens
5
Inside Lens Cover
Remove the inside lens
cover by pulling top center
of lens cover from lens
holding channels.
Replace the lens cover by
gently bowing it in the cen-
ter and inserting it, one end
5
4
at a time, into the lens hold-
ing channels.
.
Auto-Darkening Lens
lens
6
Remove lens holder and
outside lens cover using in-
structions above. Press up
on lens release tab and
push auto-darkening lens
assembly from the inside to
remove.
Replace the lens by align-
ing it on the release tabs
and pressing it in until it
snaps into place.
6
260483-8 / 260482-10
Be sure the cover lens
is seated properly to
prevent fogging.
Lens Release Tab
OM-255503 Page 21