Diamir Eagle Experience Freeride Pro 서비스 매뉴얼 - 페이지 8

{카테고리_이름} Diamir Eagle Experience Freeride Pro에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamir Eagle Experience Freeride Pro 20 페이지. Eagle experience freeride pro

페이지 인쇄

Diamir Eagle Experience Freeride Pro 서비스 매뉴얼

6 DIAMIr

Service Manual for specialist dealers

4.2

Mounting the ski brake

Before mounting the ski brake make sure that the U-frame and the support plate are correctly positioned (Pictures 4.2 A/B).

Start mounting the ski brake by positioning it on the heel support and tighten the screws of the ski brake with a screwdriver by hand

(Pictures 4.2 C/D).

Check the function of the ski brake according chapter 6.4.

Picture 4.2 a

4.3

Crampons

4.3.1 Parts of crampon Axion

axion

A1 Knife

A2 Support

A3 Support lock

A4 Holding pin

Black (Picture 4.3 a1)

4.3.2 Mounting the crampon Axion

1. Open the support lock (A3) of the crampon with both thumbs (Picture 4.3 D).

2. Slide the holding pins (A4) into the bearing fork (14) respectively from below into the base plate (16) and push it upwards to the end

stop until it snaps (Pictures 4.3 E/F/G).

3. Close the support lock (A4) until it audibly snaps in (Picture 4.3 H).

We recommend mounting the Axion crampons before the tour, activating them when needed. For the descent they must be

removed.

4.3.3 removing the crampon Axion

Open the support lock (A3) with the tip or the knob of the ski pole in direction of the arrow (Picture 4.3 I).

Pull the crampon Axion down and take it off.

4.3.4 Mounting the crampon Standard

Insert the two tongues under the base plate (16) and push the crampon downwards until it snaps over the central rail (17). to remove

reverse the procedure (Picture 4.3 J).

If the rubber sole of the boot is worn out you have to use the crampon clip available as an accessory.

Picture 4.2 B

Black (Picture 4.3 a2)

Picture 4.2 c

Red (Picture 4.3 B)

Picture 4.2 D

Standard

B1 Knife

B2 Plastic piece of crampon

(Picture 4.3 c)