Miller 1034 운영자 매뉴얼 - 페이지 7

{카테고리_이름} Miller 1034에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller 1034 12 페이지. Fluid head

Operating Instructions

2. Camera Set-up

2.1 Remove the CAMERA PLATE by pressing the RELEASE

KNOB while pulling the CAMERA PLATE out.

2.2 Refer to the Camera's owners manual for correct method of

attachment to the CAMERA PLATE. Inspect the CAMERA

PLATE and remove the ¼" and 3/8" screws (for HDV

mount) or the ¼" + PIN CARRIAGE (DVCAM mount)

as required.

2.3 Attach camera accessories and the battery to the camera,

it is recommended to estimate the camera's Centre of

Gravity (C of G) for the purpose of correctly positioning

the camera on the CAMERA PLATE. The camera's C of G

can be estimated by placing the camera on to a round rod

and then shifting it backwards or forwards until a balance

point – C of G - is achieved. It is recommended to identify

this point on the camera as it will be useful in step 2.5.

2.4 Attach the CAMERA PLATE to the camera and securely

tighten the screws.

2.5 Check that the SLIDE LOCK is loose, then align the

CAMERA PLATE with the SLIDING PLATFORM and slide it

in until the safety mechanism is engaged.

2.6 Position the CAMERA PLATE so that the camera's C of G

is directly above the centre axis of the Fluid Head and

tighten the SLIDE LOCK. If this can not be achieved then

reposition the CAMERA PLATE on the Camera – step 2.4.

This will ensure that the system has maximum stability.

C of G

Fig. 5

Sliding

platform

Sliding

platform

lock