Miller 1055 운영자 매뉴얼 - 페이지 4
{카테고리_이름} Miller 1055에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller 1055 17 페이지. Fluid head
페이지 인쇄
Introduction
Thank you for purchasing the Cineline 70 Fluid Head. The
Cineline 70 Fluid Head is purpose-built for film/digital
production cinematographers who want a new dimension in
professional camera support.
The robust design and construction of the Cineline 70 Fluid
Head is ideal for use on feature films, documentaries and
high-end television commercial productions that require heavy
payload, frequent re-rigging and a diverse range of lenses and
camera accessories. It is set to accommodate industry-leading
cameras, including Arri, Sony, RED, and Canon.
The Cineline 70 features an Arri-compatible side-loading
camera platform, along with an easy-to-fit 1225 Mitchell Base
Adaptor to suit traditional Mitchell Base tripods. Side and
front mounting locations are also provided to accommodate
a wide range of accessories such as the view finder and the
front box.
The Fluid Drag and Counterbalance system was designed
to provide excellent ergonomics and control by offerring
progressive and equal increments of drag and torque to give
ultra-soft starts / stops and perfect diagonal drag transition.
The controls are located on a single backlit panel and allow
the users a highly functional means of controlling all aspects
of the camera motion.
The Cineline 70 will give best performance when used on
a Miller Ø150 HD Tripod or the Miller HD Mitchell Base
Tripod. This will ensure maximum system stability to suit any
professional set-up.
Safety Instructions
Please use this manual to familiarise yourself with the
operation of the Cineline 70 Fluid Head and observe these
instructions to prevent any damage to your equipment.
Ensure that all equipment is operating correctly and free from
defects and damage, also please ensure that the tripod is
steady, secure and that the bowl is approximately horizontal
when attaching the camera. The operator is responsible for
the safe operation of this piece of equipment.
Do not exceed the maximum payload capacity of the Fluid
Head.
Do not leave the camera unattended on the Fluid Head.
Do not release the SIDE LOAD LOCK LEVER whilst the
camera is at an angle.
Do not adjust the tripod whilst the camera is attached to the
Fluid Head.
Ensure PAN HANDLE CLAMP and CLAMP NUT is securely
tightened.
Apply TILT LOCK when adding/removing equipment from
the camera or when attaching/removing the camera from
the Fluid Head.
Hold camera securely whilst changing Counterbalance, Pan
Drag or Tilt Drag settings.
Hold camera securely whilst adjusting the CLAMP NUT to
level the Fluid Head.
4