Miller 16 CB PLUS CiNX 3 운영자 매뉴얼 - 페이지 12

{카테고리_이름} Miller 16 CB PLUS CiNX 3에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller 16 CB PLUS CiNX 3 16 페이지. Fluid head

Maintenance

The CiNX Fluid head offers high quality surface coatings, dust

and moisture seals. Miller recommends keeping the Fluid head

clean at all times by using soft brushes and lint free cloth to wipe

over the surfaces.

• Do not immerse the Fluid head in any liquid.

• Do not use stiff brushes, abrasives, harsh detergents and

solvents.

The CiNX Fluid head uses a single GP23A type - 12 Volt battery

for Illumination. Miller recommends the following batteries to

provide long life performance – Duracell MN21/23, Eveready A23

or Vinnic L1028.

• Using a Phillips head #1 screw driver, remove the two

RETAINING SCREWs, BATTERY DOOR and the old battery.

• Insert the new battery as shown in (Fig. 12).

• Insert the tab on the BATTERY DOOR into the body first then

align the two screw holes and tighten the screws snugly.

Illumination Button

Battery

Battery Door

Retaining Screw

Fig. 12