Diamir Eagle 12 사용 설명서 - 페이지 3

{카테고리_이름} Diamir Eagle 12에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamir Eagle 12 11 페이지. Safety alubar system

Operating instructions Safety Alubar System

• If you have purchased this binding on the internet, a specialist dealer must mount and adjust the binding. If any mountings and settings have

been made by an unauthorised person, we will not be liable.

• Check your binding each time before use. If any parts are damaged or missing, it should not be used.

• Any alterations to the binding, improper mounting and adjustment or use with incompatible accessories, increase the risk of non-release or defec-

tive release.

• The bindings must be mounted directly on the ski (without extraneous components), especially so that the functioning of the ski brakes is not

impaired.

• Only use the binding with a corresponding ski brake. Failure to observe this can result in the ski sliding down without breaking after release,

endangering people's life and health.

• The braking action of the ski brake is not sufficient in the deep snow.

• Worn or damaged boots can have a negative influence on the release. Get your equipment annually check by a specialist dealer.

• Settings higher than DIN value 10 are not subject to DIN ISO standards. Settings in this numbers are at your own risk.

Care, storage, warranty

The warranty provided by Fritschi AG Swiss Bindings is given on condition that these operating instructions are observed.

The binding must be checked and if necessary readjusted before each new season by a specialist dealer.

Any repairs must be carried out by a specialist dealer or by the manufacturer.

Care

Remove all kind of material. If the binding is dirty, clean it with a damp cloth or rinse it carefully. If too much water or pressure is used the grease

may be rinsed out.

Storage

When storing the binding close the heel unit.

When transported protect the binding from dirt and salt.

After alpine touring and / or skiing, store the skis in a dry and warm room. This prevents the binding mechanism from icing or corrosion.

Warranty

An executed warranty certificate provides consumers with a warranty for 24 months from the date of purchase for any defects that can be shown

to be attributable to manufacturing errors or faulty material. The warranty does not apply to rental bindings. The warranty is only valid if work done

on the bindings such as mounting, adjusting, adaptation and repairs has been performed by a specialist dealer.

Damage that arises through natural abrasion, excessive or improper use, external influences such as fire, heat, water, etc., through non observance

of the instructions, improper care, no or non conform maintenance, are not considered as defects and are, thus, excluded from all warranties.