Miller ICE-27T 소유자 매뉴얼 - 페이지 18

{카테고리_이름} Miller ICE-27T에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller ICE-27T 36 페이지. Air-cooled torches for plasma arc cutting
Miller ICE-27T에 대해서도 마찬가지입니다: 소유자 매뉴얼 (36 페이지), 소유자 매뉴얼 (38 페이지)

페이지 인쇄
Miller ICE-27T 소유자 매뉴얼

4-11. Connecting Input Power

18 in
(460 mm)
.
Serial Number/Rating Label
located on bottom of base;
use label to determine input
power for unit.
Y Installation must meet all National
and Local Codes − have only
qualified
persons
installation.
Y Special installation may be required
where gasoline or volatile liquids
are present − see NEC Article 511 or
CEC Section 20.
.
The Auto-Line circuitry in this unit
automatically links the power source to
OM-225 216 Page 14
Y Do Not cut off power cord connector and rewire. The power cord
connector and plugs will work with standard NEMA receptacles.
Modifying power cord, connector, and plugs will void product
warranty.
the primary voltage being applied,
either 115 or 230 VAC.
make
this
For 120 volts ac input power, a 15 or 20
ampere individual branch circuit protected
by time-delay fuses or circuit breaker is
required. For 240 volts ac input power, see
Section 4-8.
1
Power Cord Connector
2
Plug − NEMA Type 5−15P
3
Receptacle − NEMA Type 5−15R
(Customer Supplied)
18 in
(460 mm)
4
5
Select plug for power supply receptacle
available at site. Install plug onto power
cord adapter. As threaded collar is tight-
ened, push plug onto adapter until collar is
completely tight.
Connect plug to receptacle.
1
2
3
4
5
804 504-A
Plug − NEMA Type 6−50P
Receptacle − NEMA Type 6−50R
(Customer Supplied)