Miller ICE-40C 소유자 매뉴얼 - 페이지 22
{카테고리_이름} Miller ICE-40C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller ICE-40C 40 페이지. Air-cooled torches for plasma arc cutting
Miller ICE-40C에 대해서도 마찬가지입니다: 소유자 매뉴얼 (40 페이지), 소유자 매뉴얼 (38 페이지)
5-3. Trigger Safety Lock
5-4. Plasma Cutting System Practices
Always connect work clamp to a clean,
paint-free location on workpiece, as close to
cutting area as possible.
°
90
Maintain approximately a 90
workpiece surface for proper cutting results.
1/8 in
(3.2 mm)
When doing extended (non-shielded)
cutting, maintain approximately 1/8 in
standoff between electrode and surface.
OM-2239 Page 18
Trigger Locked
.
Set correct air pressure for process:
75 PSI (517 kPa) for cutting,
55 PSI (379 kPa) for gouging.
°
Sparks should pass through the workpiece
angle to the
and out the bottom when cutting.
DO NOT put pressure on shield when
drag cutting; instead, slide shield along
the surface for proper cutting results.
1
Trigger Unlocked
speed is too fast or amperage is set too low.
Wt
or template for accurate cutting operations.
1
Trigger
The pilot arc starts immediately
when trigger is pressed.
DO NOT start pilot arc without cutting or
gouging as this shortens the service life
of the nozzle and electrode.
If sparks flare back from surface, this
usually is an indication that either travel
Pulling rather than pushing the torch
makes cutting easier. Use a proper guide
Ref. 803 640-A / 801 400-B / Ref. 802 878
801 397-A