Miller ICE-40C 소유자 매뉴얼 - 페이지 31
{카테고리_이름} Miller ICE-40C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller ICE-40C 40 페이지. Air-cooled torches for plasma arc cutting
Miller ICE-40C에 대해서도 마찬가지입니다: 소유자 매뉴얼 (40 페이지), 소유자 매뉴얼 (38 페이지)
페이지 인쇄
6-6. Troubleshooting Torch
Does arc go
on
and
while cutting?
Does arc go out
while cutting?
Do sparks come
out of top of cut;
or cut is not
clean?
Are
lights On; unit
has no cutting
output?
Go to Section 6-5.
Torch travel speed too slow;
increase travel speed (see
Section 5-5). Clean
Yes
replace torch consumables
off
as necessary (see Section
6-3). Be sure work clamp is
securely
workpiece.
No
Be sure work clamp is
securely attached to work-
piece. Make sure tip is on or
Yes
near, 1/16 in (1.6 mm) to 1/8
in (3.2 mm) workpiece (see
Section 5-5). Clean or
replace torch consumables
as necessary (see Section
6-3).
No
Torch travel speed too fast;
reduce travel speed (see
Section 5-5). Clean or
replace torch consumables
Yes
as necessary (see Section
6-3). Be sure work clamp is
securely
workpiece. Unit not capable
of cutting metals thicker
than rating (see Section
4-1).
No
Check torch consumables.
Check for gas/air flow at
Trouble
torch. Check air supply con-
Yes
nection and pressure to unit
and torch. Reset unit Power
switch. *Check torch and
connections inside unit.
No
or
Go to Section 6-5.
attached
to
Go to Section 6-5.
attached
to
Go to Section 6-5.
*Servicing procedure to be performed
only by authorized Service Station.
OM-2239 Page 27