Miller ICE-55CM 소유자 매뉴얼 - 페이지 4
{카테고리_이름} Miller ICE-55CM에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller ICE-55CM 38 페이지. Air-cooled torches for plasma arc cutting
페이지 인쇄
5.
Installing 25 Ampere Torch And Work Cable
11
6
13
7
4
12
Tools Needed:
5/8 in
OM-1593 Page 4
8
8
9
5
10
1
2
3
!
Turn Off power source, and
disconnect input power plug
from
receptacle
before
installing torch and work
cable.
Remove top and screws holding
front panel in place. Without discon-
necting any plugs, move front panel
to allow access.
Torch Connections
1
Strain Relief Clamp
2
Torch Cable
Insert cable through strain relief
clamp.
3
Gas Connector
4
Gas Valve
Install gas connector onto gas
valve.
5
Plug PLG18
6
Safety Control Board PC2
7
Receptacle RC18
Connect PLG18 to RC18. Route
leads along existing lead bundle.
8
Female Friction Terminals
9
Male Friction Terminal
10 Power Control Board PC1
11 Receptacle RC4
Connect female terminals to leads
23 and 24 from RC4 (connect to
either lead). Connect male terminal
to lead 25 from RC4. Route leads
as shown.
Work Cable Connections
12 Strain Relief Clamp
Insert work clamp lead through
strain relief clamp.
13 Receptacle RC6
Connect work clamp lead to lead 20
from RC6 (leads not shown). Route
leads along existing lead bundle.
801 423 / Ref. 801 300-B