Miller ICE-80CM 소유자 매뉴얼 - 페이지 19

{카테고리_이름} Miller ICE-80CM에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller ICE-80CM 38 페이지. Air-cooled torches for plasma arc cutting

21. Troubleshooting For 25, 27, 40, 50, 55, 80, And 100 Ampere Torches

Trouble

Power source Cup trouble light On; no

cutting output.

Sparks come out top of cut, or cut is not

clean.

Arc goes out while cutting.

Arc goes on and off while cutting.

Tighten cup onto torch and reset Power (see Section 15).

Check torch connections on power source. See power source Owner's Manual.

Torch travel speed too fast; reduce travel speed (see Section 13).

Clean or replace worn consumables as necessary (see Section 17).

Metal being cut is too thick; increase output control setting. See power source Owner's Manual.

Be sure work clamp is securely attached. See power source Owner's Manual.

Make sure torch tip is contacting metal while cutting.

Be sure work clamp is securely attached. See power source Owner's Manual.

Clean or replace worn consumables as necessary (see Section 17).

Torch travel speed is too slow; increase travel speed (see Section 13).

Clean or replace worn consumables as necessary (see Section 17).

Be sure work clamp is securely attached. See power source Owner's Manual.

Remedy

OM-1593 Page 19