Miller W-250(WP-20) 소유자 매뉴얼 - 페이지 15
{카테고리_이름} Miller W-250(WP-20)에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller W-250(WP-20) 25 페이지. W-250 / wp-20 series hand-held water-cooled tig (gtaw) torch
페이지 인쇄
B. Connecting Torch To A Dynastyt 200 Or MaxstarR 200 TIGRunnert Unit
Tools Needed:
5/8, 7/8, 1-1/8 in.
11
10
12
C. Connecting Torch To A SyncrowaveR 250 DX Or 350 LX TIGRunner Unit
6
9
8
10
7
11
2
1
9
7
6
8
4
5
803 311-A
4
3
2
1
5
Tools Needed:
11/16 in.
!
Turn Off welding power source
and cooling system power be-
fore installing torch.
1
Gas Hose With 5/8-18 Right-Hand
Fittings (Customer Supplied)
Connections:
2
Regulator/Flowmeter
3
Gas Cylinder
3
4
Coolant System
5
Torch
6
Coolant-Into Torch Hose (Blue)
7
Torch Gas Hose
8
Coolant-Out Of Torch/Power
Cable (Red)
9
International Style Adapter
Connect coolant-out of torch/power
cable to power cable adapter, and con-
nect adapter to weld output terminal.
10 Work Clamp
Connect work clamp to a clean, paint-
free location on workpiece, close to the
weld.
Use wire brush or sandpaper to clean
weld joint area.
11 Welding Power Source
12 Foot Control
!
Turn Off welding power source
power before installing torch.
1
Gas Hose With 5/8-18 Right-Hand
Fittings (Customer Supplied)
Connections:
2
Gas Cylinder
3
Regulator/Flowmeter
4
Power Source
5
Coolant System
6
Torch
7
Coolant-Into Torch Hose (Blue)
8
Coolant-Out Of Torch/Power
Cable (Red)
Connect torch coolant-out of torch/pow-
er cable to power cable adapter, and
connect adapter to weld output terminal.
9
Torch Gas Hose
10 Work Clamp
Connect work clamp to a clean, paint-
free location on workpiece, close to the
weld.
Use wire brush or sandpaper to clean
weld joint area.
11 Foot Control
OM-225 425 Page 11
804 994-C