Miller 8812 매뉴얼 - 페이지 19

{카테고리_이름} Miller 8812에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller 8812 24 페이지. Beam anchors

INSTALLATIONS:

1. LOCATE AND IDENTIFY A STRUCTURE CAPABLE OF WITHSTANDING

A 5,000 LB. LOAD.

2. PULL UP ON PLUNGER TO RETRACT AND SLIDE THE FOOT END SUCH THAT

MAXIMUM DISTANCE IS BETWEEN THE HOOK ENDS.

3. PLACE THE BEAM ANCHOR OVER THE BEAM AND, WHILE

RETRACTING THE PLUNGER, SLIDE THE HOOK ENDS TIGHT

AGAINST THE BEAM.

4. RELEASE THE PLUNGER AND SLIDE THE ADJUSTABLE HOOK END

SUCH THAT THE PLUNGER DROPS INTO THE NEXT AVAILABLE HOLE.

WARNING: BE SURE THE BEAM ANCHOR IS SNUG ON THE BEAM

AND THE PLUNGER IS RETRACTED INTO THE HOLE.

5. ON MODEL 8815, THE CLAMPING SCREW MUST BE USED TO ADJUST THE CLAMPING

FOOT END SUCH THAT THE BEAM ANCHOR IS TIGHT ON THE BEAM OR COLUMN.

REFER TO THE INSTRUCTION MANUAL FOR INSPECTION PROCEDURES.

WARNING:

– CONNECTORS AND ANCHORAGE POINTS MUST BE

COMPATABLE AND ABLE TO SUPPORT 5,000 LBS.

– RIG BEAM ANCHOR IN ACCORDANCE WITH REGULATORY

REQUIREMENTS.

– USER MUST ALLOW FOR 3'-6" EXTENSION DISTANCE

BEYOND THE LENGTH OF AN ATTACHED SHOCK ABSORBER.

– DO NOT ALLOW ATTACHED SOFTSTOP OR WEBBING TO COME

IN CONTACT WITH SHARP OR ABRASIVE SURFACES, SPARKS OR

TEMPERATURES ABOVE 180 DEGREES.

– REMOVE FROM SERVICE IF DAMAGE IS DETECTED.

– MAXIMUM WORKING LOAD IS 310 LBS.

INSPECTION TAG

J F M A M J J A S O N D

PUNCH GRID ON DATE OF FIRST USE

MILLER SHADOW LABELS

ÉTIQUETTES SHADOW MILLER

ETIQUETAS SHADOW DE MILLER

LB335

LB336

LB367