Miller 8815 매뉴얼 - 페이지 19
{카테고리_이름} Miller 8815에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller 8815 24 페이지. Beam anchors
INSTALLATIONS:
1. LOCATE AND IDENTIFY A STRUCTURE CAPABLE OF WITHSTANDING
A 5,000 LB. LOAD.
2. PULL UP ON PLUNGER TO RETRACT AND SLIDE THE FOOT END SUCH THAT
MAXIMUM DISTANCE IS BETWEEN THE HOOK ENDS.
3. PLACE THE BEAM ANCHOR OVER THE BEAM AND, WHILE
RETRACTING THE PLUNGER, SLIDE THE HOOK ENDS TIGHT
AGAINST THE BEAM.
4. RELEASE THE PLUNGER AND SLIDE THE ADJUSTABLE HOOK END
SUCH THAT THE PLUNGER DROPS INTO THE NEXT AVAILABLE HOLE.
WARNING: BE SURE THE BEAM ANCHOR IS SNUG ON THE BEAM
AND THE PLUNGER IS RETRACTED INTO THE HOLE.
5. ON MODEL 8815, THE CLAMPING SCREW MUST BE USED TO ADJUST THE CLAMPING
FOOT END SUCH THAT THE BEAM ANCHOR IS TIGHT ON THE BEAM OR COLUMN.
REFER TO THE INSTRUCTION MANUAL FOR INSPECTION PROCEDURES.
WARNING:
– CONNECTORS AND ANCHORAGE POINTS MUST BE
COMPATABLE AND ABLE TO SUPPORT 5,000 LBS.
– RIG BEAM ANCHOR IN ACCORDANCE WITH REGULATORY
REQUIREMENTS.
– USER MUST ALLOW FOR 3'-6" EXTENSION DISTANCE
BEYOND THE LENGTH OF AN ATTACHED SHOCK ABSORBER.
– DO NOT ALLOW ATTACHED SOFTSTOP OR WEBBING TO COME
IN CONTACT WITH SHARP OR ABRASIVE SURFACES, SPARKS OR
TEMPERATURES ABOVE 180 DEGREES.
– REMOVE FROM SERVICE IF DAMAGE IS DETECTED.
– MAXIMUM WORKING LOAD IS 310 LBS.
INSPECTION TAG
J F M A M J J A S O N D
99
00
01
02
03
PUNCH GRID ON DATE OF FIRST USE
MILLER SHADOW LABELS
ÉTIQUETTES SHADOW MILLER
ETIQUETAS SHADOW DE MILLER
LB335
LB336
LB367
19