ABB Endura AZ40 매뉴얼 - 페이지 3

{카테고리_이름} ABB Endura AZ40에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB Endura AZ40 16 페이지. Oxygen and carbon monoxide equivalent (coe) analyzer
ABB Endura AZ40에 대해서도 마찬가지입니다: 작동 지침 (16 페이지), 사용 설명서 (20 페이지)

페이지 인쇄
ABB Endura AZ40 매뉴얼
3.2.4 Endura AZ40 sensor – high operational temperature
on exposed parts
WARNING – Bodily injury
High temperature on exposed surfaces –
see Fig. 3.1
— During operation, exposed sensor surfaces can
reach 200 °C (392 °F).
— Ensure suitable PPE is available and is worn before
handling the sensor.
— Do not touch exposed surfaces until the sensor /
probe is cool enough to handle with PPE.
Fig. 3.1 High temperature points on exposed sensor surfaces during
operation
3.2.5 Endura AZ40 sensor – weight
WARNING – Bodily injury
– The sensor weighs
a probe / filter assembly, the combined sensor /
probe weight is dependent on probe length / type
plus filter option – refer to Operating instruction
OI/AZ40-EN for weight details.
– The sensor / probe assembly must be mounted in
accordance with the information supplied in
Operating instruction OI/AZ40-EN.
— Suitable lifting equipment must be available when
installing / removing the sensor / probe from the
process.
kg (
lb). When fitted with
9.0
20
Endura AZ40 | Sensor assembly | Heater and thermocouple kit | INS/ANAINST/008-EN Rev. B
3.2.6 Endura AZ40 analyzer – electrical
WARNING – Bodily injury
To ensure safe use when operating this equipment, the
following points must be observed:
— up to 240 V AC may be present. Ensure the supply
is isolated before removing the terminal cover
— normal safety precautions must be taken to avoid
the possibility of an accident occurring when
operating in conditions of high pressure and / or
temperature
Safety advice concerning the use of the equipment
described in this document or any relevant Material
Safety Data Sheets (where applicable) can be obtained
from the Company, together with servicing and spares
information.
Endura AZ40 transmitter – weight
WARNING – Bodily injury
– The transmitter weighs
be mounted in accordance with the information
supplied in Operating instruction OI/AZ40-EN.
— Suitable lifting equipment must be available when
installing / removing the transmitter from the
mounting.
kg (
lb) and must
7.6
17
3