Diamond +7ECMH4QE6 사용 설명서 - 페이지 10

{카테고리_이름} Diamond +7ECMH4QE6에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond +7ECMH4QE6 13 페이지.
Diamond +7ECMH4QE6에 대해서도 마찬가지입니다: 매뉴얼 (13 페이지), 매뉴얼 (13 페이지)

페이지 인쇄

IV. INSTRUCTIONS FOR THE

USER

1. COOKTOP USE

GAS MODELS

Lighting cooktop burners

The gas cock control knob has 4 positions:

Off position

pilot ignition

max. flame

min. flame

Lighting

• Press and turn knob "H" to "pilot on".

Press the knob down fully and hold a flame to the pilot in

order to light. Hold the knob down for about 20 seconds;

when released, the pilot flame must remain lit. If it does

not, repeat the operation.

• To light the main burner, turn the knob from "pilot on" to

"max. flame".

• For the minimum flame, turn the knob from "max. flame"

to "min. flame".

Turning off

• Turn the knob from "max. flame" or "min. flame" to "pilot

on".

• To shut off the pilot, press the knob lightly and turn it to

"off".

NB: Incorrect positioning of the flame spreader can create

problems in combustion.

• Before lighting the burners make sure the flame spreaders

are turned to the stop position.

1.2. ELECTRIC MODELS

• Equipped with rapid heating electric hot-plates each of

2.6 kW power.

• To ensure long life of the hot-plates, observe the following:

use flat-bottomed pots;

do not leave the hot-plates switched on without pots

or with empty pots.

do not spill cold liquids on the hot-plate when hot.

Switching on

• Turn the appliance on at the main switch.

• Turn control knob "B" of the required hot-plate, to one of

the six available positions marked on the control panel,

bearing in mind that "1" corresponds to minimum power

and "6" corresponds to maximum power.

Lighting up of green indicator "A" signals that the

corresponding hot-plate is on.

• To adjust hot-plate heat, turn the knobs firstly to "6"; on

reaching maximum cooking or boiling temperature, turn

the knob to a lower setting.

Turning off

Turn the control knobs to "0".