AQUAPHOR S550 운영 매뉴얼 - 페이지 11

{카테고리_이름} AQUAPHOR S550에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AQUAPHOR S550 20 페이지.

페이지 인쇄

Figure 6

or other suitable waste water outlet. This pipe is not

included with the softener.

• Removal of excess water through the overflow line oc-

curs by gravity. Make sure the overflow line terminates

at a drain that is at least 8 cm below the edge of the

overflow fitting. Provide an air gap of at least 5 cm.

• It is not allowed to bend the outlet tube of the over-

flow line and lift it in height.

ATTENTION! The overflow line is part of the emergency

leak protection system. In its absence, in case of mal-

function of the softener and overflow of the brine tank,

water leakage is possible.

Step 4 Connect the drain line

The drain line is designed to drain water during regener-

ation.

• Connect the drain line to the drain port (see fig. 7) us-

ing the 5/8" ID ( ~ 16mm) flexible hose supplied with

the softener. Reducing the diameter is not allowed.

• Run a drain line to a drain, washing machine drain, or

other suitable sewage outlet. Provide an air gap of at

least5 cm between the drain line and the maximum fill

level of the wastewater receiver in order to prevent

backflow.

• The drainage line must be laid in such a way that the

distance to the drain is minimal. The drainage line can

Figure 7

Gravity overﬂow

connection

• The drain line may be extended with a pipe or hose

• The drainage line should not have kinks, creases,

ATTENTION! It is not allowed to combine drainage

(pressure) and overflow (gravity) lines by means of

tees, etc.

ATTENTION! During the regeneration process, small

solid particles may appear in the drain line, which does

not indicate a malfunction of the softener.

Step 5. Flushing the water supply

• Make sure the softener valve is in the "Bypass" posi-

• Open the nearest cold water faucet and flush the pipes

NOTE: When the softener is in Bypass mode, the water

is not treated.

Step 6. Make sure the connections are tight

Close all outlet taps to pressurize the system.

Check all lines and connections for leaks. If a leak is found:

a) turn off the water supply;

b) fix all leaks;

c) turn on the water supply.

Slowly move the valve to the "Service" position (see fig. 1),

slowly, to avoid water hammer, fill the softener.

Open the nearest cold water faucet to bleed air from the

system. When water comes out of the faucet without air,

close the faucet and check for leaks.

Step 7. Connecting the controller and power supply

NOTE: Make sure the controller is securely attached to

the three latches on top of the valve.

Connect to the back of the controller:

• flow sensor connector (fig. 8),

• motor connector,

Figure 8

Sensor wire

be raised to a height of up to 1.5 m above the drain

hole of the device, while the pressure in the water

supply must be at least 0.275 MPa (2.75 bar).

of at least 3/4".

twists or other damages that restrict the flow of water.

tion (see fig. 1) Turn on the water supply.

of solder flux residue and other foreign material.

Motor wire

Power cord