AQUAPHOR CRYSTAL EKO-80-2 사용자 설명서 - 페이지 6
{카테고리_이름} AQUAPHOR CRYSTAL EKO-80-2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AQUAPHOR CRYSTAL EKO-80-2 12 페이지. Drinking water fountain
Please Note: following the applicable sanitary requirements, when using the water fountain
in various types of educational institutions, the height of the vertical jet should not be less
than 10 cm.
Preparation of the AQUAPHOR electronic cartridge wear meter for use (13) (Fig. 4)
The electronic cartridge wear counter allows you to control the wear of cartridges in the
water fountain and prompts timely replacement. The counter is fitted on the dispenser and
shows the rate of water filtration and the remaining time of the cartridge use (in litres and
days).
Before using the meter, insert the batteries (2АА batteries are not included and must be
bought separately). To insert the batteries, remove the cover and pit in the batteries
observing the polarity. The display should show "0l/m". If not, adjust the position of the
batteries. Then put the lid back on.
Setting the cartridge wear indicators in litres and days.
Holding the "SET" button down, press the "RESET" button, and then release both buttons.
The «OFF» signal will flash on the display.
Pressing the "SET" button, select the appropriate value (500 l, 1000 l, 1500 l ... 99000 l,
99500 l, OFF l, 500 l, 1000 l ...) shown on the meter display ( See the Manufacturer's
Warranties for performance information). Then, press the "RESET" button, saving the
selected value. The litre consumption indicator can be turned off by selecting "OFF".
Pressing the "SET" button, select the appropriate value (30 day, 60 day, 90 day ... 690 day,
720 day, OFF day, 30 day, 60 day ...) shown on the meter display ( See the Manufacturer's
Warranties for performance information). Then, press the "RESET" button, saving the
selected value.
The litre consumption indicator can be turned off by selecting "OFF".
Connection to the water/sewage network
- Insert the corrugated PCV hose (20) into the siphon located under the sink (19);
- Connect the loose end of the hose to the sewage system. The diameter of the sewage
outlet should be 30 mm (in the case of other dimensions, use an adapter (2));
- Check the tightness of connections;
Setting the cartridge wear indicators in litres
Setting the cartridge wear indicators in days