Chromalox RTPC 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Chromalox RTPC에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Chromalox RTPC 8 페이지. Power connection kit for self-regulating & constant wattage heating cables
Chromalox RTPC에 대해서도 마찬가지입니다: 설치 지침 (4 페이지)

페이지 인쇄

Cable installation instructions: CPR, CPM, CZH, SRL, SRM/E, SRP

CWM cable special instructions denoted by *

1. Punch out the knockouts on the bottom of the

box which correspond to the openings in the base

through which the heating cable passes. Only

punch out the knockouts that are to be used. If one

is mistakenly punched, blank grommets can be or-

dered to re-establish the water tight seal.

3. Slide cable grommet over the end of the cable and

insert it into the opening in the base. Secure the

base to the pipe by threading the appropriate sized

pipe strap through the slot in the mounting plate.

Tighten the pipe strap until the base is securely at-

tached to the pipe.

2. Feed the ends of the cables through the appropri-

ate hole in the base. Allow 8 inches of cable to ex-

tend above the top of the base.

4. Score the outer insulation 7 inches from the end of

the cable. Remove the jacket to expose the metal

braid. CAUTION: When removing outer jacket, be

careful not to damage the braid of the base cable

insulation. NOTE: If using braid only cable (-C) skip

this step.