BURL B16 MOTHERSHIP 빠른 시작 매뉴얼 - 페이지 4
{카테고리_이름} BURL B16 MOTHERSHIP에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BURL B16 MOTHERSHIP 4 페이지.
BURL B16 MOTHERSHIP에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (14 페이지)
페이지 인쇄4. Install Daughter Cards
1.
See card slot numbers and corresponding Inputs and Outputs on page 3.
2.
Daughter Cards will ship with wire assemblies already attached to the Daughter
Cards.
3.
Make sure the card is inserted into the card guides and properly connects to the
backplane.
4.
Pull cables through to the front for connection to the faceplate.
5. Attach Ribbon Cables To Faceplate
6. Re-attach Lid With All Screws
7. Install Vent ABOVE B16 Chassis
Image 12: 1U vent above B16 chassis allows for proper ventilation.
Important Installation Notes:
1.
Install the 1U vents above the B16 chassis. The MOTHERSHIP MUST run with prop-
er ventilation.
2.
Failure to properly vent the MOTHERSHIP chassis above and below may cause fail-
ure, and will void the warrenty.
8. Clocking
The B16-BMB clocks off of Internal Clock, External Word Clock or AES Channels 1/2. For
best results, we recommend clocking off of INT, Internal Clock.
Image 11: Connect ribbon cable and 2 pin
connector, where applicable.
4