Aquaport AQP-20SIL 설치 및 운영 지침 매뉴얼 - 페이지 9

{카테고리_이름} Aquaport AQP-20SIL에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquaport AQP-20SIL 16 페이지. Signature filtered water cooler

SET DATE AND TIME

1. Press and hold the D/T SET button for 5 seconds.

2. The 'Year' number in the top left hand corner will

start to flash.

3. Press the UP or DOWN button to change to the correct year.

4. Press D/T SET to set the year. The 'Month' number will

now be flashing.

5. Continue to use the UP or DOWN button to change the

numbers and the D/T SET to set and move onto the next

number.

The date and time is displayed in the following sequence:

YEAR > MONTH > DATE >>> HOUR > MINUTE > SECOND.

Note: The time is displayed as 12 hours. A small PM will

appear at 12 noon.

6. Once you have set the 'seconds' push D/T SET which will

complete setting the Date and Time.

TO SET 180 DAYS (6 MONTHS) TO FILTER REPLACEMENT

IMPORTANT: The filter cartridge AQP-FCR-Q should be replaced every

600L or 6 months, whichever occurs first. The filter change timer should

be used as a guide only to help keep track of 180 days (6 months).

If you detect a change in taste, odour or a decrease in flow before the

end of 180 days you should replace the filter.

Press and hold the DAY COUNTER SET button for 5 seconds.

Three zeros will appear. The first zero will be flashing.

Press the UP or DOWN button until the number 1 appears then

press DAY COUNTER SET button.

The second zero will now be flashing. Press the UP or DOWN button

until the number 8 appears then press DAY COUNTER SET button.

The third zero will now be flashing. Press DAY COUNTER SET

button. 180 days will now be displayed.

Every 24 hours the number will decrease by 1 day until it gets to

zero, at which time the beeper will sound for 45 seconds. The filter

cartridge should be replaced at this time. If you do not hear the

beeper the day display will remain on zero days, the filter cartridge

should be replaced.

Reset the day counter every time you replace the filter cartridge by

following these instructions.

Note: To save power the display will turn off after 2 minutes of no use.

To display the information press any button.

INSTALLATION AND OPERATING INSTRUCTIONS 7