Aquaport AQP-3TAP-SS 설치 및 운영 지침 매뉴얼 - 페이지 5

{카테고리_이름} Aquaport AQP-3TAP-SS에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquaport AQP-3TAP-SS 16 페이지. Platinum water dispenser hot/cold & room
Aquaport AQP-3TAP-SS에 대해서도 마찬가지입니다: 설치 및 운영 지침 매뉴얼 (16 페이지)

페이지 인쇄

A. Platinum Water Dispenser Installation Instructions for Spring

Water Bottles.

Please follow the instructions below if you are using a

spring water bottle.

Do not turn on the water cooler until the following instructions have

been followed.

1. Vertically insert a spring water bottle into the bottle supporter

on top of the water cooler, the spike will pierce the bottle cap.

You will see bubbles appear inside the bottle, wait until the

bubbling has stopped before dispensing water from both taps.

Note:

If you are applying a spring water bottle to the water cooler

for the first time and you do not see any bubbles appear inside

the bottle, open both taps until the bubbling starts and water

flows from both taps. Refer to the trouble shooting guide for more

information.

2. Once the bubbling has stopped, drain 1-2lts of water from both

taps.

Note:

The water cooler has been flushed before it left the factory

however we strongly recommend 1-2 litres of water is flushed

through the unit before using.

3. Insert the power plug into the wall socket, and turn the power

switches ON. The power switches are situated at the rear of

the unit.

Note:

The green power switch is for turning the cold water

function ON. The red power switch is for turning the hot water

function ON.

4. At the front of the unit there are 3 indicator lights, the orange

LED on the top is the power light and will continually illuminate

while the unit is turned on. The Red LED heating light in the

middle will illuminate when the unit is heating the water and

when heating is finished the Red LED heating light will turn off.

The Green LED cooling light at the bottom will illuminate when

the compressor is running and cooling the water, when cooling

is finished the Green LED cooling light will turn off.

5. The hot water tap has a child safety device installed. To

operate the hot tap you must turn the child safety button anti

clockwise and push tap inwards.

6. When the unit is turned on for the first time, allow the unit to

cool and heat the water for 1-2 hours before dispensing the

water.

INSTALLATION AND OPERATING INSTRUCTIONS 3