Aquaport AQP-WCS-FBOT4 설치 및 운영 지침 매뉴얼 - 페이지 10

{카테고리_이름} Aquaport AQP-WCS-FBOT4에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquaport AQP-WCS-FBOT4 16 페이지. Executive filtered water cooler cold / room

Aquaport AQP-WCS-FBOT4 설치 및 운영 지침 매뉴얼
TROUBLE SHOOTING
BEFORE YOU CALL FOR SERVICE PLEASE REVIEW THE TROUBLE SHOOTING TIPS FIRST.
Problem
Water is leaking
between bottle
and water cooler
at bottom of the
Filtered Water
Chamber.
No water flow
through filter
cartridge.
No power.
Not cooling
INSTALLATION AND OPERATING INSTRUCTIONS
Possible Causes
Universal float valve not installed correctly.
Float gasket of universal float valve not
completely sealing valve base hole.
Filter cartridges have exceeded its longevity.
The water level in filter holder chamber
is too low.
Unit is not plugged into the wall socket.
Power switch at rear of unit is turned off.
Fuse has blown.
Unit is not plugged into the wall socket.
Power switch at rear of unit is turned off.
Unit may have been laid down during
Transport.
What To Do
Please unscrew, and re-screw universal float valve to the
valve base located at bottom of the Filtered Water Chamber.
Push universal float up-wards, check to see if float gasket
seals valve base hole completely. If problem persists contact
Aquaport.
Replace filters.
Fill Unfiltered Water Chamber with water.
Check connection to wall socket.
Turn unit on from rear power switch.
Replace with new fuse.
Check connection to wall socket.
Turn unit on from rear power switch.
If the unit has been laid down during transport, keep the unit
upright for 48 hours before turning on. If still not cooling call
customer service on 1300 764 325.