Aquaport AQP-FKM1 설치 및 운영 지침 매뉴얼 - 페이지 8

{카테고리_이름} Aquaport AQP-FKM1에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquaport AQP-FKM1 17 페이지.

페이지 인쇄

B. Water Supply Installation

Preferred Installation

(Utilising existing kitchen sink water supply and flexible

faucet tubing)

A typical connection using the included water supply fitting is

shown on Page 5.

1 Locate cold tap water pipe and turn water supply off at the

isolation tap. If no isolation tap is available, turn off at the

meter. Turn on tap at sink to check and ensure water is turned

off and to drain the pipe.

2. Remove the flexible cold water hose that connects the cold

water faucet to the cold mains connection. Some water may

spill out.

3. Wrap sealing tape (6) around cold water stud in a clockwise

direction.

Note: Do not apply sealing tape in a counter clockwise direction, it

releases the sealing tape and leaks may occur.

4. Making sure that the washer is inserted correctly into the

female connection of the mains connection (5), hand tighten

the mains connection to the mains cold water stud (please see

Fig 1). Finish tightening with an adjustable wrench.

6 INSTALLATION AND OPERATING INSTRUCTIONS

Be careful not to over tighten, as cross threading and leaking

can occur. Make sure the shut off valve connection is not

against a wall as the 1/4" tubing must not be bent, see Page 5.

5. Wrap sealing tape (6) around male thread of mains connection

(5) in a clockwise direction.

6. Reconnect the flexible cold water hose to the mains

connection (5).

7. Install 1/4" tubing (3). (see tubing installation section D)

Note: Inspect the ends of the tubing

to be sure there are no imperfections

and that the end of the tubing is cut

square. It may be necessary to cut

the tubing again.

Note: Plumbing connections may

vary, please consult a qualified

plumber for correct installation

method for your home.

Fig 1

Flexible

Cold

Water

Tap

Hose

1/4" Tubing

to filtration kit

Mains Cold

Water Isolation

Outlet