Diamond CSP/4 매뉴얼 - 페이지 8

{카테고리_이름} Diamond CSP/4에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond CSP/4 8 페이지.

CHAP. 7 - MAINTENANCE

7.1 - GENERAL FEATURES

Before starting any maintenance activity it is necessary:

a) to disconnect the power supply plug from the socket to isolate the CUTTER

from the electric circuit completely.

b) if the CUTTER is a vv model, to set the speed dial knob to the "0" position.

7.2 - BELT

The belt does not need to be adjusted. Generally it must be replaced after 3/4

years; in this case, please call the "SERVICE CENTRE".

7.3 - FEET

Feet might deteriorate and lose elasticity; consequently the stability of the

machine might be reduced.

In this case they must be replaced.

7.4 - POWER SUPPLY CORD

Periodically check whether the power supply cord is worn-out and, if this is the

case, please call the "SERVICE CENTRE" to have it replaced.

7.5 - BLADES

Check that blades have not lose more than 5 mm of thickness after sharpening.

Call the "SERVICE CENTRE" to have them replaced.

7.6 - KEYBOARD LABEL

The label of the keyboard could be marked and/or holed. In this case, please call

the "SERVICE CENTRE" to have it replaced.

CHAP. 8 - DISPOSAL OF THE MACHINE

8.1 - PUTTING THE MACHINE OUT OF SERVICE

If for some reason, you decide to put the machine out of service, make sure

nobody can use it: disconnect it from the mains and eliminate the electrical

connections.

8.2 - DISPOSAL OF THE MACHINE

When the machine is out of service, it can be eliminated. To dismantle the

machine contact a Specialized Centre, paying attention to the different materials

used ( see chap. 1 par. 3.2 ).