Aquaport AQP-TAP-4S 설치 및 운영 지침 매뉴얼 - 페이지 7

{카테고리_이름} Aquaport AQP-TAP-4S에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquaport AQP-TAP-4S 14 페이지. Filtered water sink mixer 4 way tap

C. Faucet Installation Instructions

Warning: Do not use any tools to fix the flexible metal

connectors. Hand tight pressure only.

Warning: Do not over tighten the Flexible Metal Connectors to

the tap connections, as cross threading and leaking can occur.

Water tightness is not improved and the o-rings can be damaged.

Note: This tap must be installed with an isolating tap in

accordance with local authority installation codes.

1. Shut off mains water supply and drain any excess water from

the old tap before removing the tap from the sink.

2. Locate the Mains Cold and Hot Water Connections (2 & 3) inlet

on the tap (marked with the letters C and H).

3. Firmly hand tighten the Flexible Metal Connectors (9) into

the tap inlets, being careful not to over tighten and to avoid

damage to the o-ring seals.

4. Thread the Flexible Metal Connectors (9) and tap shanks (4 &

5) through the Mixer Base (14a).

Note: Check to make sure the mixer base o-ring is still present and

is fully seated in place.

5. Mount the tap onto the sink hole, by threading the Flexible

Metal Connectors (9) and tap shanks (4&5) through the sink

hole and position the Mixer base (14a) between the sink and

the tap.

6. Ensure that the Flexible Metal Connectors (9) are positioned

towards the front of the sink with the lever handles pointing

towards the user and tap shanks (4 & 5) are positioned at the

back.

7. Thread the Fixing Plate Washer (14b) and then the Fixing Plate

(14c) onto the Ambient Filtered Water Shank (5).

Screw Locking Nut (14d) onto the Ambient Filtered Water

shank (5) and lock the tap onto the sink by tightening the

Locking Nut.

Note: Tap levers must never be used to align the tap in centre

positions after Locking Nut has been tightened. Damage to levers

will occur. Loosen Locking Nut before aligning the tap in the centre

of the sink.

9. Place the Brass Adapter Red Washer (10) into the female end

of the Brass Adapter (11) and screw Brass Adapter onto the

end of the Ambient Filtered Water Shank (4).

INSTALLATION AND OPERATING INSTRUCTIONS 5