Burley G4249 설치 및 서비스 매뉴얼 - 페이지 12
{카테고리_이름} Burley G4249에 대한 설치 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Burley G4249 17 페이지. 49 model flueless gas heater
페이지 인쇄14.
Operating Instructions for remote operation
NOTE THIS SECTION REPLACES THE SECTION 'TO LIGHT THE HEATER' CONTAINED IN
THE USERS INSTRUCTIONS
Batteries – The handset takes a standard 9v battery. This should be changed annually
1.
to ensure the fire continues to operate correctly. It can be accessed through a flap on
the back of the handset.
The fire is fitted with a special 7.2volt rechargeable battery available from your
retailer or from Burley Appliances on 01572 756956. It can be changed by simply
sliding it out of its housing under the fire, undoing the connector block and carefully
replacing with a new one
We regret that the warranty does not cover items such as batteries.
2.
When disposing of batteries, always do so in an environmentally friendly manner.
On first operation, ensure the thermostat is set to the hot position.
3.
Ensure the infra red sensor is visible. The fire relies on line of sight between the sensor
4.
and handset to operate. If a different fret is fitted it is possible to swivel and slide the
sensor into a clearer position. In the event of the fire not working check both of the
above points before calling an engineer.
To ignite the fire, point the handset at the fire, push and hold simultaneously the 2 left
5.
hand buttons marked * and ● for several seconds until the igniting sequence begins.
The fire will automatically light the pilot light, monitor its safety for about 20 seconds
and then it will light the burner on high flame.
To alternate between high and low flame use the flame buttons on the right hand side
6.
of the handset.
To turn the fire OFF press the ● button on the top left hand side of the remote
7.
handset.
The fire is fitted with a comfort thermostat behind the ash pan door and it is possible
8.
to set this to modulate the fire between off and on. If the pilot is alight but the main
burner will not light, check the position of this thermostat before changing batteries
etc.
An audible signal is heard when the fire receives a signal from the handset. This will
9.
help you to know that the fire has received your instruction and is changing settings.
When the battery power is low, a continuous bleep will be heard from the fire and it
will allow you to shut down safely but will not reignite. Please then recharge.
Page 12 of 16