Diamond F100 T/L 매뉴얼 - 페이지 8

{카테고리_이름} Diamond F100 T/L에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond F100 T/L 12 페이지.

페이지 인쇄

6.1 Troubles during operation

CAUTION: For all the operations described below, disconnect the display cabinet from

the mains and address to specialized personnel who have a sufficient knowledge of the

functions of the different parts and of the precautions to be taken.

Below are listed some possible malfunctioning and the likely cause and remedy. If you cannot

solve the problem or if it is not provided in the following table, call our customer technical

service:

MALFUNCTIONING

The pilot light is off and

the display cabinet is not

refrigerated

The green pilot light is

and

the

display

cabinet

refrigerated

The orange pilot light is

and

the

display

cabinet is not illuminated

7.1 Instructions for cleaning

Routine maintenance essentially consists of daily cleaning all the parts that can come into contact

with the foodstuffs. The cleaning instructions to be followed are listed below:

 Make sure the electrical power supply has been disconnected by unplugging it from the socket.

CHAP 6 - MALFUNCTIONING

LIKELY CAUSE

 Power is not reaching the power

supply circuit

 Faulty

switch,

compressor

 Power

refrigerating unit

not

 Faulty

switch,

compressor

 Refrigerating fluid leakage

 Too high dissipation

 Power is not reaching the neon light

 Faulty switch or neon

CHAP 7 - CLEANING AND MAINTENANCE

thermostat,

not

reaching

the

thermostat,

Page 7 of 11

REMEDY

 Make sure there is power in the

electric network

 Check the correct connection of the

power supply cable (§ 7.2.6)

 Check the different connections and

various electrical components and

replace them if necessary (§ 7.2.1

and § 7.2.3)

 Make sure there is power in the

electric network

 Check the correct connection of the

power supply cable (§ 7.2.6)

 Check the different connections and

various electrical components and

replace them if necessary (§ 7.2.1

and § 7.2.3)

 Check the refrigerating gas circuit

 The display cabinet is positioned in a

too hot place

 The automatic closing system is not

operating correctly, take care over

the closure of the sliding doors.

 Make sure there is power in the

electric network

 Check the correct connection of the

power supply cable (§ 7.2.6)

 Check that the switch on the neon is

on.

 Check the different connections and

various electrical components and

replace them if necessary.