Burley PICCOLO 소유자 및 안전 매뉴얼 - 페이지 4

{카테고리_이름} Burley PICCOLO에 대한 소유자 및 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Burley PICCOLO 20 페이지. Trailercycle
Burley PICCOLO에 대해서도 마찬가지입니다: 브로셔 및 사양 (5 페이지), 소유자 사용 설명서 (12 페이지), 소유자 지침 및 안전 매뉴얼 (10 페이지), 소유자 사용 설명서 (8 페이지), 소유자 사용 설명서 (16 페이지)

II.

Initial Piccolo Assembly

IMPORTANT: All assembly of trailercycle and Moose Rack

must be per formed by your Burley dealer.

Mount the Pedals

The pedals are stamped either "R" for right or "L" for left. Take care to mount the

cor rect pedal to the correct crank arm. Apply a small amount of grease to the pedal

threads to make installation easier. Tighten pedals securely—torque to 25 ft.-lb.

Mount the Handlebars

To make it easier to orient the stem and handlebars, ﬁ rst mount the handlebar to

the stem. The splash guard is preinstalled to the stem and must be left in place for

safe operation of the trailercycle. Do not fully tighten the han dle bars until the stem

is attached and tightened in place.

Adjusting and Tightening the Piccolo Handlebar Stem

The tongue of the Piccolo has an ovalized section to ensure that the stem and

handlebar cannot rotate during use. The ﬁ nal correct place ment of the stem

depends upon the height of the child, but as a starting place mount the stem 8"

from the junction of the Piccolo top tube and the tongue. The top edge of the stem

should never be more than 12" from this junction. Torque the two stem bolts and

the handlebar bolt to 9 ft.-lb. Do not overtighten.

Install the Twist Shifter & Grips

Use the short handlebar grip as a guide to position the twist shifter on the right

handlebar. Do not tighten the twist shifter retaining bolt until the short handlebar

grip is installed. Position the twist shifter and tighten the twist shifter retaining bolt

securely. Slide the left grip fully onto the handlebar. Adjust the derailleur to shift

cleanly.

Mount the Seat

Mount the seat clamp to the seat, and then attach this assembly to the seat post.

Next, insert the seat post into the seat tube. Final ad just ment should be made to ﬁ t

the child prior to the ﬁ rst ride.

The Piccolo comes with a removable seat-post clamp. When in stall ing the seat-post

clamp or adjusting seat post height, note that the slot in the seat tube must align

with the slot in the seat-post clamp (see illustration page 5).

Burley Piccolo Owner's Instruction & Safety Manual