Burley SOLO 소유자 지침 및 안전 매뉴얼 - 페이지 8

{카테고리_이름} Burley SOLO에 대한 소유자 지침 및 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Burley SOLO 12 페이지. Child trailers
Burley SOLO에 대해서도 마찬가지입니다: 소유자 지침 및 안전 매뉴얼 (15 페이지), 브로셔 및 사양 (5 페이지), 설치 지침 (2 페이지), 소유자 지침 및 안전 매뉴얼 (8 페이지), 소유자 지침 및 안전 매뉴얼 (20 페이지), 소유자 및 안전 매뉴얼 (8 페이지), 소유자 지침 및 안전 매뉴얼 (20 페이지)

Two passengers:

For two children, use both shoulder harnesses and two outer

crotch straps.

1. Seat first child on one side of seat.

2. Snap shoulder straps into Y-buckle,

with buckle positioned at child's

sternum. Adjust straps so that child

cannot move too far forward in seat.

3. Repeat for second child.

4. Fasten and adjust lap belt

snugly. Figure 9

To remove children from seat, release lap belt and

harness buckles.

WARNING

ALWAYS SECURE CHILDREN WITH HARNESS AND LAP BELT DURINg USE. ONLY USE

THIS SEAT IF YOUR CHILD IS CAPABLE OF SITTINg UPRIgHT ALONE. FAILURE TO DO SO

COULD RESULT IN ACCIDENT AND SERIOUS INjURY OR DEATH.

Hitching Trailer to Your Bicycle

1. Remove rear quick release lever assembly from bike.

2. Match hole on flat side of hitch upper arm to left (non-chain

ring side) rear dropout hole.

3. Loosely reassemble quick release assembly through hitch,

dropout and wheel.

4. Slide flex connector between hitch side arms, and match

holes. Racks, bags, or fittings should not interfere with hitch.

B U R L E Y C H I L D T R A I L E R O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L

Figure 10

5. Open retaining pin and insert through hitch and flex

connector holes. Rotate and close spring clip.

6. Tighten and close quick release lever, with lever pointing to

rear of bike. A properly adjusted quick release lever should

leave an imprint on your palm when the lever is rotated to the

closed position.

7. Wrap safety strap twice around chain stay and then over

hitch body. Fasten hook to D-ring on underside of tow bar

end.

8. To remove trailer from bicycle, unfasten clip from D-ring and

remove retaining pin.

WARNING

qUICk RELEASE LEvER MUST BE IN CLOSED POSITION AND HITCH SAFETY STRAP

PROPERLY INSTALLED. HITCH MUST NOT INTERFERE WITH RACkS, BAgS OR FITTINgS.

INSPECT HITCH AND TOW BAR FREqUENTLY FOR DAMAgE OR LOOSE FASTENERS.

DAMAgED, IMPROPERLY INSTALLED OR INTERFERINg PARTS CAN CAUSE ACCIDENTS

RESULTINg IN SERIOUS INjURY.