Burley Jogger 소유자 지침 및 안전 매뉴얼 - 페이지 4

{카테고리_이름} Burley Jogger에 대한 소유자 지침 및 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Burley Jogger 20 페이지.
Burley Jogger에 대해서도 마찬가지입니다: 소유자 지침 및 안전 매뉴얼 (6 페이지)

Installing the Jogger on Your Trailer

1. Observe (Figure 1) to see completed installation. Note the

downward curve of the bars and the orientation.

2. Slide the jogger arms into the receiver on both sides. Refer

to your trailer manual for directions on how to properly

secure products for your specific trailer receiver.

3. Pull on the jogger arms to ensure they are securely

attached to the receivers.

4. Insert the quick release lever skewer through the hub of

the wheel, making sure there is a spring on either side of

the hub. Screw the nut on loosely (Figure 2).

5. Place the wheel in the wheel dropouts (Figure 3).

6. With the QR handle pointing away from the wheel, tighten

the nut so that you feel resistance halfway through

closing the lever. Do not tighten the quick release lever by

spinning the lever.

7. Close the quick release lever. The lever should point

downward.

8. Make sure your handlebar is at the right height for jogging.

If necessary, adjust the handlebar to a better height. See

trailer manual to adjust your handlebar.

ENG

Figure 1

Figure 2

Figure 3

JOGGER KIT