ChronoRemoteControl XT4 868 SLH 프로그래밍 매뉴얼 - 페이지 3

{카테고리_이름} ChronoRemoteControl XT4 868 SLH에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ChronoRemoteControl XT4 868 SLH 3 페이지. Faac remote controls

5) Release the buttons and try your new remote control.

6) Perform a test of your new remote control.

Coding based on the receiver:

CAUTION: The coding operation will cause deprogramming remotes already in use

on this system.

1) Open the electronic cabinet of your motorization.

2) Press simultaneously the buttons P1 and P2 on the remote control already in

use and release them when the remote control flashes.

3) On the receiving card (RP, Decoder, Minidec), press and hold the self-

learning button so that the LED on the card flashes.

4) While holding down the self-learning key, press and hold a button on the

remote control until the LED on the receiver card stays on for 2 seconds.

5) Release all.

6) Wait 10 seconds before a trial run with your new remote control.

7) Close the radio receiver.