Burlington R9 CHR 빠른 시작 매뉴얼

{카테고리_이름} Burlington R9 CHR에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Burlington R9 CHR 2 페이지. Summer electric heating kit
Burlington R9 CHR에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (7 페이지)

페이지 인쇄

This summer electric heating kit allows you the benefit of heat from your bathroom radiator on cooler days

without the need to run your complete central heating system. When incorporated the electric heating element

heats only the bathroom radiator, and the water does not get circulated to the other radiators in your home. It

does not prevent the circulation of water into the bathroom radiator when the central heating pump is running,

and thus does not need to be removed again once installed.

Position:

This summer electric heating kit is intended to be installed in a bathroom or shower-room. It is IP44 rated and may

be installed in the Zone 2 area (see Fig below), but the electrical connection box must be outside the Zone 2 area.

Zone 1

Zone 2

60cm

Zone 0

(1) Side view, bath

Fitting into the bathroom radiator:

The product should be installed by a competent plumber.

The bathroom radiator must be isolated from the rest of the central heating system by closing its shut-off/control

valves, and then drained. If isolation cannot be achieved, then the complete central heating system must be

drained down to below the level of the bathroom radiator (note that when refilling it may be necessary to top-up

any corrosion inhibitor in the system).

The heating element should be inserted into the radiator, do not overtighten.

The isolating valves should be opened and the radiator bled of all air.

Electrical connection:

The sealed heating element is supplied complete with its own mains cable. Do not use an extension cable. It is a

3-wire product which must be earthed. It should be connected to the household fixed wiring by a qualified

electrician in accordance with the national Wiring Regulations (BS.7671). A switch for disconnection from the

electricity supply, having a contact separation in all poles that provide full disconnection under overvoltage category

III conditions, must be incorporated in the fixed wiring. A switched spur outlet incorporating a 3A fuse may be used,

but this must be positioned outside the Zone 2 area (i.e. further away from the bath or shower). The national Wiring

Regulations also require that each circuit supplying a bathroom must be protected by a 30mA RCD in its supply.

USER INSTRUCTIONS

Safety warnings:

a) This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction

concerning use of the appliance by a person responsible for their safety.

b) Children should be supervised to ensure that they do not play with the appliance.

c) As when the central heating system is operating, this summer electric heating kit will cause the bathroom

radiator to get hot to touch during operation.

Summer

Electric Heating Kit (150W for Cleaver & Berkeley & Vincent)

Summer

Electric Heating Kit (250W for Bloomsbury)

Summer

Electric Heating Kit (400W for Trafalgar)

Zone 1

Zone 0

Zone 1

(2) Top view

1 - 2

60cm

Zone 2

60cm

R10 CHR

Zone 1

Zone 2

60cm

Zone 0

(3) Side view, shower

R8 CHR

R9 CHR