Diamond SNE/RN-B7-R2 설치 및 사용 설명서 지침 - 페이지 6

{카테고리_이름} Diamond SNE/RN-B7-R2에 대한 설치 및 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond SNE/RN-B7-R2 9 페이지. Fixed 60 80 and rotating 60 vertical cooling display

페이지 인쇄

Starting

- Press on the on/off switch (n°3 on picture) to start the unit. The electronic

thermostat turns on.

- Wait for the unit to be at the right temperature (stop of the compressor).

- Press on the light switch (n°2 on picture) to start the light and activate rotating

plate (rotating model)

Temperature setting

The electronic thermostat is preset in factory. It can be adjusted if necessary.

To modify the temperature, refer to the technical documentation of the

thermostat.

Regulation of defrost

The defrost is an important operation for ventilated refrigerating displays.

A homogeneous temperature is ensured thanks to the air circulation through the

evaporator. This evaporator has a negative temperature when the compressor is

working. In this way, its blades "trap" the humidity as frost, and the air of the

chamber dries. If there is too much frost, the air cannot circulate through the

evaporator and the internal temperature rises.

In order to avoid this phenomenon, the defrost programmed in the factory stops the

compressor 10 min every 2 hours.

These values can be adjusted by your technician. It depends on the type of products

presented in the refrigerating display, on the use and the environment.

Stopping the machine at night or on closing days is recommended for total defrost

§10.

Stopping the appliance

Set each switch (n°2 and 3 on picture) on 0: the appliance is no longer

functioning.

Disconnect the power supply cable.

Clean the appliance. (See 6. Cleaning)