Burlington Emporer T13B 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} Burlington Emporer T13B에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Burlington Emporer T13B 2 페이지.
페이지 인쇄● There are two ways in which you can connect the drain pipe to the waste.
3a
Method 1) If you have a waste that comes up through the floor, you can connect to it
with a flexible drain pipe which enables you to tilt the bath up and move the
bath into the required position. To avoid water retention in the trap
the flexible pipe should have a continuous downward flow
4a
● Place the bath on two wooden blocks over the waste connections.
● Connect the waste. Fill the bath with water and check for leakage.
4b
● The rigid pipe should be connected to the drain pipe outside bath.
● Connect the waste. Fill the bath with water and check for leakage.
3b
Method 2) If under-floor access is impossible, an additional hole of approx 45mm
5
● Securing your bath to the floor!!!
When the bath is in position and the installation is complete, It is recommended
back view
that you apply a bead of clear silicone sealant around the bottom of the bath to
secure it to the floor.
● Should maintenance access be needed the silicone can be released by cutting
round it with a sharp knife.
2 - 2
diameter can be drilled through the outer skin of the bath to allow the trap
to be connected to a rigid pipe.
24H
B