Burlington T24 설치 지침

{카테고리_이름} Burlington T24에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Burlington T24 2 페이지.

페이지 인쇄

INSTALLATION INSTRUCTIONS

2 tap hole arch mixer with curved spout

(200mm centers)

2 tap hole arch mixer with curved spout

(230mm centers)

Important

● We recommend that this product is installed by a qualified professional contractor. Such as a plumber who is certified by NVQ

(National Vocational Qualification) or SNVQ (Scottish National Vocational Qualification) Level 3

● Please check this product immediately to ensure that it has not been damaged and is complete. Before installation, please make

sure this product is the correct model and you have all the parts required for installation and using.

● All the taps in Burlington Range should be supplied with hot and cold water at balanced pressure. If not, then the mixing function

will not work correctly. It is necessary to fit non-return valves on both hot and cold feeds pipe. These are not supplied.

● Please flush the water system to ensure that no metal swarf, solder, and other impurities can enter the taps.

● Turn off water supply before commencing work, this should be done at the isolating valves of inlet feeds if fitted or main stopcock.

● Please read these instructions carefully and keep it for future reference.

Working pressure

The tap is suitable for both high and low pressure installation. To ensure that the tap works well under low water pressure, the

cold water storage tank must be at least 2 meters above the installed position. The maximum static pressure is 10 bar, and

operating water pressure is 5 bar. Where the operating water pressure above 5 bar, then a pressure reducing valve must be fitted.

Straightener and aerator (alternative option)

The tap comes with a factory-fitted flow straightener for low pressure water systems.

If the water flow is high, replace the factory-fitted flow straightener with the high pressure

aerator supplied.

Use NEOPERL Key to unscrew the straightener in the Nozzle. Replace with the aerator

provided, and screw back in nozzle tightly. (If you misplace the Neoperl key you can use

the top of the aerator/straightener as a key)

Cleaning

Before use: Unscrew the filter and allow the water to run freely for

5 minutes. Then screw the filter back in place.

Periodically: Using the key provided unscrew the nozzle and remove.

Rinse it with cleaning running water until any loose debris is cleared.

Then replace the nozzle and tighten with key provided.

T24

T25

Option 1:

Burlington has 4 different style handle for your selection.

Anglesey

Claremont

Option 2:

Burlington also have a base (27mm height) for your selection.

NOT INCLUDED IN THE TAP BOX

NOZZLE

KEY

1 - 2

Birkenhead Kensington

(For Quater

turn only)

FLOW STRAIGHTENER

AERATOR