Aquarii RHEOS 설치 매뉴얼 - 페이지 8

{카테고리_이름} Aquarii RHEOS에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquarii RHEOS 11 페이지. Slope recessed

COMMUNICATION CONNECTIONS

See the DMX Wiring for a Zino LED Fixture in the diagram below:

Follow the steps below to secure the DMX/RDM Connections to the fixture.

1. Determine the present Communication Board, then secure the DMX Communication Wiring to the board based on the

local sites wiring options. The four possible options are:

• XLR - 5 Pin (P/N: 17-00005)

• RJ-45 (P/N: 17-00004)

• Insulation Displacement Connector (IDC) (P/N: 17-00003)

• Screw Terminal (P/N: 17-00002)

2. Ensure the DMX Wire Harness connection from the Controller to Communication Board has not been disrupted.

3. Set the fixtures DMX Address as needed.

NOTE:

All DMX Wiring should be compatible with Telecommunications Industry Association TIA/EIA-485 (RS-485). See the table on

Page 7 of this manual for the required DMX over CAT5e/6 Information.