Diamond C400S/VT 매뉴얼 - 페이지 5

{카테고리_이름} Diamond C400S/VT에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond C400S/VT 10 페이지.

REVERSING THE DOOR

How to reverse the door

Remove the lower hinge by loosening and removing the screws with scredriver.

Carefully lower the door and remove it.

Remove the two screws from the left top hinge position, take the metal part off the hinge

position.

Remove the two screws from the right top hinge and take off the hinge, insert the metal part,

rivet the two screws thereafter.

Take off the lower hinge and fix it to the opposite side.

Take the door. Insert the lower hinge axle into the right bottom hole of the door.

Fix the spare hinge to the left top position of the cabinet. Adjust the door, make it straight and

in alignment with the cabinet.

Note: As the door gasket gets pressed-in during shipment, after reversing the door the gasket might

have to be reset. This will be good for seal to avoid any air escaping. If there is a gap between the

cabinet and the door gasket, set the gasket by gently pulling it out to seal the gap. If necessary, you

are recommended also to use the hair drier to warm the gasket to get rid of the gap.

Warning:To avoid electric shock always unplug you absorption refrigerator before cleaning.

Ignoring this warning may result in injury.

General:Do not use harsh chemicals, abrasives, ammonia, chlorine bleach,

concentrated detergents, solvents or metal scouring pads. SOME of

these chemicals may dissolve, damage and/or discolor your absorption refrigerator.

1) Remove the contents of the appliance

2) Wipe the inside and outside surfaces with a damp cloth. The addition of vinegar to the

water is good for the prevention of mold and fungus.

3) Wipe all parts thoroughly after the cleaning.

IMPORTANT:

When the absorption refrigerator is not in use it must be completely dry inside to avoid mold

growth (if possible have the door open).